How to knot between beads
Wednesday, April 23, 2008 at 11:41AM Basic Knotting Technique

My favorite method for knotting between beads is the traditional awl-and-tweezers technique.

Begin with a length of beading cord that is at least four times longer than you'd like the finished jewelry to be. Finish one end of the cord with an end finding, or make a simple overhand knot several inches from one end (and leave that end to finish later). String the first bead.
Now, holding the bead in your dominant hand, wrap the cord around the index and middle finger of your other hand, like this:

Point your index and middle finger downward, and then drop the bead through the loop of cord between them - with the bead falling toward your fingertips.


Insert a knotting awl into the loop, with the point toward your fingertips. Remove your index and middle finger to drop the loop. Press your index finger against the upper part of the awl to keep the loop from slipping off.

Pull the end of the cord away from the awl to slide the loop - which should close into a loose knot - down against the bead.

Remove the awl, and use knotting tweezers to push the knot as snuggly as possible against the bead.


Repeat this process for each bead that you would like to string with knots. If you knot an entire strand, then by the time you reach the end you will be dropping the strand of beads down through the loop of cord between your fingers. That is normal - it just takes a little practice to get comfortable with.
As an alternative to using an awl and tweezers, you can use a specialty knotting tool (like the Beadalon model shown below) that serves the same function.

It will allow you to make the knot and push it down against the bead without having to switch tools. However, I actually find the traditional method easier and faster - and the equipment is less expensive. You may want to experiment to see which you prefer.
knotting,
stringing beads in
Getting Started,
Supplies,
Techniques 
























Reader Comments